Controller To Engine Communications Failure - Xerox Phaser 7400 Service Manual

Controller to Engine Communications Failure

An communications error was detected.
Applicable Status Code:
Code F130:
Engine Communications Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Engine Control Board, PL1.1.4
Troubleshooting Procedure Table
Step Actions and Questions
1
Cycle power to the printer.
Does the error persist?
2 Reseat the CUIF connector.
Does the error persist?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 3 (page 10-6)
Print Engine Control Panel (page 10-43)
Yes
Go to Step 2.
Replace the Engine
Control Board
(page 8-112). If the
error persists,
replace the Image
Processor Board
(page 8-113)
No
Complete
Complete
3-123