Replace Imaging Unit Or Imaging Unit Is At End Of Life - Xerox 6200B - Phaser Color Laser Printer Service Manual

Replace Imaging Unit or
Imaging Unit is at End of Life
The printer's front panel displays "Replace Imaging Unit or Imaging Unit is at End of
Life" and the imaging unit has been replaced. Printer power has been cycled and the
message still appears.
Note: The "Imaging Unit is at End of Life" is a warning. "Replace
Imaging Unit" is a hard stop.
Troubleshooting Reference Table
Applicable Parts
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following parts for evidence of
fault or damage:
Imaging Unit (CRC) PL 9.1.3
CRUM Connector on the Plate Dispenser
2 Replace the Imaging Unit .
Does the error recur?
3 Verify the CRUM Harness is properly
connected.
See "Laser Unit" on page 359
4 Check CRUM Harness Assembly for
continuity.
See "Laser Unit" on page 359
5 Check the EEPROM Harness for
continuity.
See "Fuser Assembly" on page 358
Error Messages and Codes
Wiring and Plug/Jack Map References
"Laser Unit" on page 359
Yes
Replace the parts
concerned.
Go to step [3].
Go to step [4].
Go to step [5].
Replace the
Engine Control
Board, RRP 12.7.
No
Go to step [2].
Complete
Replace the
CRUM Harness
Assembly,
PL 10.1.15.
Replace the
CRUM Harness
Assembly,
PL 10.1.15.
Replace EEPROM
Harness
Assembly,
PL 13.1.10.
49