CHAPTER 3
B. Fixing Motor Unit
1) Remove the top cover unit and the left
cover unit.
2) Remove the cable from the cable guide.
3) Remove the screw and then the cable
guide.
4) Remove the screw and then the gear
cover.
Screws
Cable
Cable guide
Gear cover
Figure 3-7-2
5) Disconnect the connector (J102, 6 pins)
from the feed PCB.
6) Remove the 3 screws and then the fixing
motor unit.
Feed PCB
Connector
Cable clip
Screws
Fixing motor unit
Figure 3-7-3
Note:
Do NOT disassemble the fixing
motor unit.
3 - 52
C. Pick-up Motor
1) Remove the top cover unit and the left
cover unit.
2) Disconnect the connector (J109, 4 pins)
from the feed PCB.
3) Remove the 2 cable clips and then the
cable of the pick-up motor.
4) Remove the 2 screws and then slide the
pick-up motor in the direction of the
arrow to remove.
Connector
Feed PCB
Cable clips
Cable
Screws
Pick-up motor
Figure 3-7-4