Canon CLBR 460ps Service Manual page 182

CHAPTER 3
< Notes for reassembly >
When the drum drive unit has been disassembled, reassemble the gears as shown in figure 3-
3-8.
When installing the gears 27T and 28T, adjust their positions according to the procedures
described in figure 3-3-9.
When replacing the gears in the figure below, apply grease to the gears and shafts to prevent
noise. Type of grease and application method are described below. Do not use grease other than
the ones specified here.
Lubricating material:HY9-0007
Apply to the gears according to the instructions in the figure below.
Lubricating oil:CK-8003
Apply a drop to the shafts and side contact surface of the gears specified in the figure below.
Apply total of 0.1g lubricating material
to the contact surface of the cams.
Apply a drop of lubricating oil.
3 - 12
Apply 0.05g of lubricating material to the contact
surface making contact with the gear 230T.
(See figure 3-3-9)
46T
Apply 0.1g of grease
to the teeth.
73/17T
70T
68/20T
Figure 3-3-8
230T
27T
Apply a drop of lubricating oil.
28T
(See figure 3-3-9)
59T
138T
66T
138T