Canon CLBR 460ps Service Manual page 250

CHAPTER 3
< Notes for reassembly >
When the paper feeder pick-up drive unit has been disassembled, reassemble the gears as
shown in the figure below.
When replacing the gears specified in the figure below, apply grease to the gears and shafts to
prevent noise. Type of grease and application method are mentioned below. Do not use grease
other than the ones specified here.
Lubricating material:HY9-0007
Apply 0.12g of EM50-L to the teeth (about 5 teeth) of the gears specified in the figure below.
Lubricating oil:CK-8003
Apply a drop to the shaft specified in the figure below.
20T
Ratchet gear
3 - 80
27T
14/18T
53T
31/39T
49T
19T
Figure 3-10-7
23T
31T
23/27T
18T
41T
16T