Canon CLBR 460ps Service Manual page 30

CHAPTER 1
5. Unpacking and installing the duplexing unit
1) Unpack the duplexing unit and remove the carton.
2) Take out the accessories.
3) Remove the plastic bag covering the duplexing unit and remove adhesive tapes.
4) Remove the packing materials from the duplexing unit.
5) Place the duplexing unit on a flat surface.
6) Install the printer on the duplexing unit, aligning the duplexing unit positioning dowels with
the printer positioning holes.
7) Plug the pig tail of the duplexing unit into the outlet of the printer.
Note: If the printer is ON, turn it OFF and unplug the power cable before installing the duplex-
ing unit.
6. Unpacking and installing the paper feeder
1) Unpack the paper feeder and remove the carton.
2) Remove the tape holding the cassette from the paper feeder.
3) Remove the cassette from the paper feeder. Remove the packing materials.
4) Place the paper feeder on a flat surface.
5) Install the printer on the paper feeder, aligning the paper feeder positioning dowels with the
printer positioning holes.
1 - 20
2
Fig. 1-5-12
Fig. 1-5-13
1