Table of Contents
Advertisement
CHAPTER 1
4. SYSTEM SETUP menu
In the SYSTEM SETUP menu, settings relating to the printer system can be specified.
The submenus in the SYSTEM SETUP menu are shown below. (Default values are in the
square brackets.)
Submenu
PRINTER NAME
PRINT START PAGE
PUBLISH PRINTD Q
JOBS TO SAVE
POWER SAVER (M)
CHANGE PASSWORD
NEW PASSWORD
VERIFY PASSWORD
1 - 32
Options
[C LBP-460PS]
YES/NO [NO]
YES/NO [NO]
1 to 99 [10]
30 MIN/1 HOUR/
2 HOUR/3 HOUR
[1 HOUR]
YES/NO [NO]
Remarks
Use this submenu to give the printer
a name on the network.
Use this submenu to specify whether
the printer should print a start page.
The start page contains such informa-
tion as: printer name, installed
options, amount of memory installed,
network protocols enabled and exis-
tence/nonexistence of calibration.
Use this submenu to specify whether
the printed queues should be stored
in the optional hard disk or not.
Displayed only when the optional
hard disk is installed.
Use this submenu to choose the num-
ber of jobs to be saved in the Printed
Queues. Displayed only when "PUB-
LISH PRINTD Q" is set to "YES".
Use this submenu to specify the
length of time during which there is
no printer activity before the printer
switches to Power Saver mode. Full
power mode is automatically restored
when the printer receives a print job
or any key on the control panel is
pressed.
Use this submenu to set or change
the administrator password for the
printer.
To set a new password, use the arrow
key to enter a password.
Displayed only when "CHANGE PASS-
WORD" is set to "YES".
To verify a new or existing password,
you must enter the password again.
Advertisement
Chapters
Table of Contents
Troubleshooting
