40-Fan - Canon CLBR 460ps Service Manual

CHAPTER 3
3) Remove the screw, disconnect the con-
nector, and then slide the 60-fan unit to
the direction of the arrow to remove.
Screw Connector
60-fan unit Fan shield plate 2
Figure 3-7-13
4) Unhook the 3 claws and then remove
the 60-fan from the 60-fan unit.
Note: When installing the fan, make sure
that the arrows of the fan case and
the fan are pointing at the same
direction.
Figure 3-7-14
3 - 56
I.

40-fan

1) Remove the upper front cover unit.
2) Remove the 4 screws on the upper front
cover and then the internal cover.
Screws Internal cover
Figure 3-7-15
3) Remove the screw and then the connec-
tor cover.
4) Remove the drawer open/close arm.
Screw
Pins
Connector cover
Drawer open/close arm
Figure 3-7-16