Canon CLBR 460ps Service Manual page 25

C. Unpacking and Installation
If the boxed printer is brought into a warm place from a cold place, condensation will form on
the printer surfaces. This will cause various problems, such as print defects. To stop this hap-
pening, leave the printer in its box to acclimatize it to room temperature before unpacking it.
This will take at least an hour.
1. Unpacking
1) Open the packaging.
2) Take out the accessories. Confirm that the power cord (100 to 127V), toner cartridges (total:
4), and drum cartridge are included.
Confirm that the universal cassette and ITB unit are installed in the printer.
3) Have two persons lift and carry the printer to the installation site. Two persons are required
to move the printer because it weighs about 48 kg.
4) Remove the plastic bag from the printer and peel the tape off it. Confirm that the covers
were not damaged or deformed during transport.
5) Remove the universal cassette from the printer and remove the packing material.
6) Open the ITB unit drawer and remove the tape and packing material.
7) Take out the ITB unit and remove the packing material of the secondary transfer roller.
Note: When connecting the printer to the computer, make sure to turn them OFF and unplug
the power cord from the power outlet before connecting (disconnecting) the interface in
order to prevent accidents and damages.
Fig. 1-5-3
Fig. 1-5-4
CHAPTER 1
1 - 15