Developing Rotary - Canon CLBR 460ps Service Manual

CHAPTER 3
11) Slide the rotary unit in the direction of
the arrow, release the pin and then
remove the unit.
Rotary unit Pin
Figure 3-3-25
12) Remove the 4 screws and then the
plate.
13) Remove the E-ring and then the cam.
Screws Plate
E-ring Cam
Figure 3-3-26
3 - 20
14) Holding the shaft, lift up the developing
rotary to remove.
Shaft

Developing rotary

Figure 3-3-27
< Note for reassembly >
The position of the bushing should be as
shown in the figure below when installing
the developing rotary.
Developing rotary
Bushing
Figure 3-3-28