Oht Sensor; Density Sensor - Canon CLBR 460ps Service Manual

V. OHT Sensor
1) Remove the multi-purpose tray PCB
according to the multi-purpose tray
PCB removal procedure on page 3-62.
W. Density Sensor
1) Open the drum cartridge drawer.
2) Remove the 2 screws.
3) Unhook the 3 claws and remove the
shield plate.
Screws Claws
Shield plate
Figure 3-5-17
4) Unhook the 2 claws and remove the
connector cover.
Claws Connector cover
Figure 3-5-18
5) Disconnect the connector and remove
the density sensor.
Note: Do NOT peel off the seal attached to
the detection window of the density
sensor.
CHAPTER 3
3 - 45