G. Delivery Unit
1) Refer to the 60-fan removal procedure
1) to 3) on page 3-55 to remove 60-fan
unit.
2) Disconnect the connector from the face-
down tray paper full sensor.
3) Remove the 3 screws.
4) Slide the delivery unit in the direction of
the arrow and then remove the unit.
Connector
Screws
Delivery unit
Figure 3-3-18
H. Drum Cartridge Drawer Unit
1) Remove the rear door switch unit
according to the toner cartridge door
open detection switch removal proce-
dure 1) and 3) on page 3-35.
2) Remove the cable from cable clip.
3) Remove the 5 claws and then remove
the cable guide.
Cable
Cable clip
Claws
Cable guide
Figure 3-3-19
4) Disconnect the 2 connectors (J1004,
J1010) from DC controller.
CHAPTER 3
3 - 17