Reassembly And Remounting - Suzuki VZ800 Service Manual

FRONT AXLE
Measure the front axle runout using the dial gauge. If the runout
exceeds the service limit, replace the front axle with a new one.
 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
 Wheel axle runout
Service Limit: 0.25 mm (0.010 in)
TIRE 2-23

REASSEMBLY AND REMOUNTING

Reassemble and remount the front wheel in the reverse order of
removal and disassembly. Pay special attention to the following
points:
WHEEL BEARING
• Apply SUZUKI SUPER GREASE "A" to the bearings before
installing.
 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Install the wheel bearings with the used bearings and special
tool as described below.
 A 09941-34513: Bearing installer set
B 09913-70210: Bearing installer set (40 mm)

* First install the right wheel bearing, then install the
left wheel bearing.
* The sealed covers on the bearings must face to the
outside.
Left
Right
Left
CHASSIS 8-9
Right
Spacer
Clearance