3-50 ENGINE
NOTE:
Using the hand-press is recommended to remove the crankshaft
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
09924-84510: Bearing installer set
09924-74570: Final drive gear bearing remover/installer
• Set the specified crankshaft journal bearings to the special
tool.
* Before setting the bearing, apply enough engine oil
to the special tool and bearings.
* When setting the bearing, align the bearing side with
the engraved line A and also the bearing edge with
the mating surface of the special tool.
09913-60241: Journal bearing remover/installer
• Tighten the special tool bolt to the specified torque.
Special tool bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Before installing the bearings, lightly shave off the
sharp edge part of the crankcase chamfer by using an
oilstone and wash the crankcase bore with enough
engine oil.
Bearing
Sharp edge