Inspection And Disassembly - Suzuki VZ800 Service Manual

INSPECTION AND DISASSEMBLY

SPACER
• Remove spacer from swingarm.
• Remove the spacers from the cushion lever.
• Inspect the spacers for any flaws or other damage. If any
defects are found, replace the spacers with new ones.
SWINGARM BEARING
Insert the spacer into swingarm cushion rod upper side bearing
and check the play to move the spacer up and down.
If excessive play is noted, replace the bearing with a new one.
Inspect the swingarm pivot bearing, its race and dust seal for
wear or damage. If any defects are found, replace the bearing
with a new one.
• Remove the swingarm pivot right side bearing plate 1 and
bearing races 2 by using a suitable bar and so on.
NOTE:
The swingarm pivot right side bearing and its plate are available
as one component.
• Remove the swingarm pivot bearing races by with the special
tool.
 09921-20240: Bearing remover set (30 mm)

The removed bearings must be replaced with new
ones.
• Remove the swingarm cushion rod upper side bearings by
with the special tool.
 09921-20240: Bearing remover set (17 mm)

The removed bearings must be replaced with new
ones.
CHASSIS 8-43