Suzuki VZ800 Service Manual page 367

9-18 ELECTRICAL SYSTEM
GEAR POSITION SWITCH
• Remove the secondary gear case cover. (8-40)
• Disconnect the gear position switch coupler and check the
continuity between Blue and Black/White with the transmis-
sion in "NEUTRAL".
 09900-25008: Multi circuit tester set
 Tester knob indication: Continuity test ()
ON (Neutral)
OFF (Except neutral)

When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch to "ON" position and side-stand to
upright position.
• Insert the needle pointed probes to the gear position switch
coupler.
Measure the voltage between Pink and Black/White lead wires
using the multi circuit tester when shifting the gearshift lever
from low to top.
 09900-25008: Multi circuit tester set
09900-25009: Needle pointed probe set
 Tester knob indication: Voltage ()
 Gear position switch voltage: 0.6 V and more
(
* Low to top gear position
* Except neutral position
Blue Black/White
(Pink + – B/W -)
)
V