Suzuki VZ800 Service Manual page 148

4-16 SHAFT DRIVE
• Remove the bearing retainer screws, using an impact driver
set.
 09900-09004: Impact driver set
• Remove the final driven gear bearing C and oil seal D with
the special tools.
 09941-64511: Bearing remover
09930-30104: Sliding shaft

The removed bearing and oil seal must be replaced
with new ones.
NOTE:
If no abnormal noise, the bearing removal is not necessary.
• Remove the final drive gear bearing with the special tools.
 09923-73210: Bearing remover
09930-30104: Sliding shaft

The removed bearing must be replaced with a new one.
NOTE:
If no abnormal noise, the bearing removal is not necessary.
• Remove the oil seal E and O-ring F from the bearing stopper.

The removed oil seal and O-ring must be replaced with
new ones.
NOTE:
If no oil leakage, the oil seal removal is not necessary.
INSPECTION
Inspect the removed parts for the following abnormalities.
* Drive and driven bevel gear damage or wear
* Improper tooth contact
* Abnormal noise of bearings
* Bearing damage or wear
* Oil seal damage or wear
* Propeller shaft spline damage or wear