Suzuki VZ800 Service Manual page 119

• Install the primary drive gear and tighten the primary drive
gear bolt to the specified torque with the special tool.
 Primary drive gear bolt: 95 N·m (9.5 kgf-m, 68.5 lb-ft)
 09930-40113: Rotor holder
NOTE:
This bolt has left-hand thread.
GEARSHIFT
• Install the washer 1.
• Install the gearshift cam stopper plate after aligning the gear-
shift cam pins A with the gearshift cam stopper plate holes
B.
• Install the washer 2.
• Apply a small quantity of THREAD LOCK "1342" to the gear-
shift cam stopper bolt 3 and tighten it.
 99000-32050: THREAD LOCK "1342"
• Install the cam driven gear 4 after installing the springs, pins
and gearshift pawls.
• Install the cam guide and the pawl lifter.
• Apply a small quantity of THREAD LOCK "1342" to the nuts.
 99000-32050: THREAD LOCK "1342"
ENGINE 3-73