Suzuki VZ800 Service Manual page 156

4-24 SHAFT DRIVE
• Apply Lithium Base Molybdenum grease (NLGI #2) to the pro-
peller shaft splines and final drive bevel gear coupling.
• Install the spring 6 and propeller shaft 7.
 99000-25140: SUZUKI MOLY PASTE
• Install the snap ring 8.
• After installing the propeller shaft with a new snap ring, make
sure that the propeller shaft turns smoothly without any hitch
or bearing noise.
 09900-06108: Snap ring pliers
• Install the oil seal with the special tool.
 09940-51410: Steering bearing installer
09925-18011: Bearing installer
• Apply grease to the lip of the oil seal.

Use a new oil seal to prevent oil leakage.
 99000-25030: SUZUKI SUPER GREASE "A" (USA)
99000-25010: SUZUKI SUPER GREASE "A" (Others)
• Install the stopper plate 9.

When installing the plate, fit the protrusion B of plate
to the one of the bearing stopper grooves.
NOTE:
Two kinds of plates are available to lock the stopper at the
proper position.