Using The Multi-Circuit Tester - Suzuki VZ800 Service Manual

USING THE MULTI-CIRCUIT TESTER

• Properly use the multi-circuit tester + and - probes.
Improper use can cause damage to the motorcycle and
tester.
• If the voltage and current values are not known, begin mea-
suring in the highest range.
• When measuring the resistance, make sure that no voltage is
applied. If voltage is applied, the tester will be damaged.
• After using the tester, be sure to turn the switch to the OFF
position.
 09900-25008: Multi-circuit tester set

Before using the multi-circuit tester, read its instruc-
tion manual.
NOTE:
* When connecting the multi-circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
* Use the needle pointed probe to prevent the rubber of the
water proof coupler from damage.
 09900-25009: Needle pointed probe set
ELECTRICAL SYSTEM 9-5