8-8 CHASSIS
INSPECTION
WHEEL BEARINGS
Inspect the play of the wheel bearings by finger while they are in
the wheel. Rotate the inner race by finger to inspect for abnor-
mal noise and smooth rotation.
Replace the bearing in the following procedure if there is any-
thing unusual.
WHEEL BEARINGS REMOVAL
• Remove the wheel bearings by with the special tool A or B.
09921-20240: A Bearing remover set (17 mm)
or 09941-50111: B Wheel bearing remover
The removed bearings should be replaced with new
ones.
FRONT WHEEL
Make sure that the wheel runout (axial and radial) does not
exceed the service limit when checked as shown. An excessive
amount of runout is usually due to worn or loose wheel bearings
and can be corrected by replacing the bearings. If bearing
replacement fails to reduce the runout, replace the wheel with a
new one.
Wheel rim runout (axial and radial)
Service Limit: 2.0 mm (0.08 in)