Replacing A Cd-Rom Or Dvd-Rom Drive; Figure 7-6 Removing And Replacing A Cd-Rom Or Dvd-Rom Drive - Sun Microsystems Sun Blade 100 Service Manual

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Remove the following from the back of the CD-ROM or DVD-ROM drive
(
FIGURE 7-6
CD-ROM or DVD-ROM drive IDE cable connector
Power cable connector
4. Using a No. 2 Phillips screwdriver, remove the two screws securing the CD-ROM
or DVD-ROM drive to the chassis.
5. Place your fingers on the back of the CD-ROM or DVD-ROM drive. Push the CD-
ROM or DVD-ROM drive toward the chassis front and remove it.
6. Place the CD-ROM or DVD-ROM drive on an antistatic mat.
FIGURE 7-6
7.4.2

Replacing a CD-ROM or DVD-ROM Drive

Note – Before you replace the CD-ROM or DVD-ROM drive, verify that the drive
back panel mode-select jumper is set to "CS," "Enable Cable Select," or "Cable
Select."
):
Removing and Replacing a CD-ROM or DVD-ROM Drive
Chapter 7 Removing and Replacing Storage Devices 7-11