Replacing A Cd-Rom Drive Or 4-Mm/8-Mm Tape Drive - Sun Microsystems Ultra 1 Creator Series Service Manual

FIGURE 9-9
9.3.2 Replacing a CD-ROM Drive or 4-mm/8-mm Tape
Drive
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Position and align the CD-ROM drive or 4-mm/8-mm tape drive on the surface
edge of an antistatic surface (
2. Position the chassis bracket on top of the CD-ROM drive or the
4-mm/8-mm tape drive.
Positioning the CD-ROM Drive or 4-mm/8-mm Tape Drive
FIGURE 9-9
Screw (4)
CD-ROM drive or
4-mm/8-mm tape drive
).
Chapter 9
Chassis bracket
Diskette
drive
Storage Devices 9-11