Selecting Paper Tray, Mff, Or Manual Feed Mode - Fujitsu PrintPartner 20W User Manual

Control Panel Functions
2-12
05 Chapter 2

Selecting Paper Tray, MFF, or Manual Feed Mode (

Pressing
TRAY SELECT TRAY SELECT
allows you to set paper sources in locked or unlocked status. In the
locked status, the paper source selection is fixed. In the unlocked
status, the paper source is automatically switched to another source
in a certain condition (auto tray selection). The paper sources are
tray 1, trays 2 to 4 (if installed), and MFF (in MFF mode or in
manual feed mode).
The MFF operation is controlled by MFF mode in which "first"
mode and "cassette" mode are provided.
First mode
The MFF has the highest priority and is selected first of all if
printing is requested. You do not need to set the paper size of the
MFF. (The MFF paper size menu is disabled.) The printer starts
printing assuming that the loaded paper has the job-specified size
of paper.
If you are printing using tray 1, 2, 3, or 4 with this mode set, you
can immediately switch the tray to the MFF just by putting paper
on the MFF. This is called on-demand printing.
Cassette mode (default)
The MFF is controlled in the same manner as for other paper
trays. However, it has the lowest priority as compared with trays 1
to 4. You must set the physical size of the paper loaded on the
MFF, using the MFF paper size menu. If the MFF paper size does
not match the job-specified size, a paper mismatch error occurs.
Manual feed mode
Besides the above two modes, the MFF has a manual feed mode.
Operation slightly differs with the two modes.
In first mode:
If paper is already loaded on the MFF, it is picked without the
paper insertion request message. If paper is not loaded on the
MFF, the paper insertion request message is displayed.
12
puts the printer in tray select mode which
27.01.1999, 15:35 Uhr
)
TRAY SELECT TRAY SELECT
User's Manual