Table of Contents
Advertisement
Setting Up
User's Manual
04 Chapter 1
This section describes how to assemble the printer and connect the
power cord after choosing a suitable location for the printer and
checking that you received all the parts.
Preparing the Print Unit and Installing the Toner Bottle
This printer is shipped with a print unit and a toner bottle. The
print unit is mounted in the printer with protective materials
attached. Be sure to remove the two protective materials from the
print unit. This operation is possible with the print unit mounted.
First prepare and install the following two components:
• Print unit (photoconductor drum, developing unit, etc.)
• Toner bottle
The toner bottle first installed after you purchase the printer or a
new print unit will last about 2500 printed pages under the
condition of 5% coverage on A4 paper. The succeeding toner bottles
last about 5000 printed pages each.
Caution:
• Do not expose the print unit to direct rays of the sun or strong
lights.
• Do not work for print unit attachment at a place exposed to strong
lights. Make every effort to finish work within five minutes.
• Do not touch the surface of the photoconductor drum.
• Do not place the print unit upright or up side down.
• Toner is harmless for human body. However, if it sticks to your
hand or clothing, wash it away immediately.
Warning:
!
• Be careful not to get toner in your eyes or mouth. If toner sticks to
your hand, wash it away promptly. Should you drink it by
accident, consult your doctor promptly.
• Do not touch any parts (fuser and its peripheral) where the "Hot"
label is affixed. It burns you. If paper clings to the fuser, do not
take the risk of removing it. Instead, turn power off promptly and
call your vendor.
11
Setting Up
27.01.1999, 15:34 Uhr
GETTING
STARTED
1-11
Advertisement
Table of Contents
