Adding Paper Sources; Second To Fourth Paper Feeders - Fujitsu PrintPartner 20W User Manual

Adding Paper
Sources
User's Manual
06 Chapter 3

Second to Fourth Paper Feeders

If you switch paper sizes frequently, you may want to add another
paper source. Or you may simply wait to increase the paper capacity
of your printer. You can easily do this by installing up to three pairs
of optional paper feeders (feeder units and paper trays).
These optional paper trays are identified as second tray, third tray, and
fourth tray and the one in the standard configuration is identified as
first tray. (Note that the three optional paper trays are identified as
first tray, second tray, and third tray when an optional duplex unit is
installed in place of the standard paper tray.)
The paper types and sizes used with optional paper trays are the same
as those for the standard paper tray. The capacity is 250 sheets or
500 sheets (twice that of the standard paper tray).
Warning:
• Before mounting or dismounting a paper feeder, set the printer
!
power switch to the "O" side and disconnect the power plug from
the outlet. Failure to do so may cause an electric shock or faults.
• If needed, touch the metal part of the paper feeder carefully so as
not to hurt your hand.
• Be careful not to get your fingers caught between the printer and
paper feeder. It may hurt you.
• The printer, with consumable items attached, weighs about 27 kg.
Two or more persons are required to carry it. When lifting the
printer, one person must firmly hold the bottom of the printer by
both hands on the left and right sides viewed from the front
(control panel side). Simultaneously, another person must hold the
printer on the opposite side in the same way. Never hold any part
other than the bottom to lift the printer. The printer may drop
and hurt workers.
11

Adding Paper Sources

27.01.1999, 15:36 Uhr
ENHANCING &
CUSTOMIZING
3-11