Table of Contents
Advertisement
Menu Items
2-28
05 Chapter 2
Config menu
Personality
Auto continue
I/O timeout
I/O buffers
Power save
On after 15 min
On after 30 min
On after 60 min
On after 120 min
Off
Pre pick
Parallel menu
Acknowledge
Mode1
Mode2
Mode3
Bi-direction
NPAP mode
28
Selecting an emulation (personality) without a
PJL command which clearly specifies the
emulation
Automatic control of continuing recoverable
errors (On: automatically clears errors other
than paper mismatch 10 seconds after an
error, Ext: automatically clears errors including
paper mismatch 10 seconds after an error)
Time interval allowed for switching the
interface
Size of interface buffer
Setting the time interval during which the
printer remains idle state before entering sleep
mode after printing last
Power save mode on. The printer enters sleep
mode after remaining idle state for ## minutes
after printing last.
Power save mode off.
Earlier start of picking paper from an optional
tray
The pulse width of the ACK signal
0.5 µs
1.0 µs
4.0 µs
Bi-directional Centronics interface mode
Whether the NPAP commands are used.
When using MarkVision™, the NPAP mode
must be Auto or On.
27.01.1999, 15:36 Uhr
User's Manual
Advertisement
Table of Contents
