Write Log; Remote - RED ONE Operation Manual

SET CLOCK
Set Clock loads the selected Date and Time parameters into the camera's system memory.
NOTE: After pushing this key the camera will require re-boot as displayed. The new parameters will
take effect, and be visible as TIME CODE, on completion of the re-boot cycle.

WRITE LOG

Select to write camera's .LOG file to CF card or RED-DRIVE® magazine. The .LOG file is a diagnostic tool
that can assist RED™ with camera troubleshooting. After capture, upload the .LOG file to the RED™ cus-
tomer service team contactable at www.RED.com/support.
After successfully writing log file to media, external monitors will display:

REMOTE

This menu provides access to controls that specify the operation of the remote ports on the camera. At
this time there is a single selection - S4/i.
Build 20 v20.1.6
88 88
©2009 RED.COM INC. OCTOBER 19, 2009