RED ONE Operation Manual page 78

CUED: Transitions the output of the GPO when a Clip is cued for Playback.
POLARITY
This menu permits the signal polarity of GPIO IN 1 and 2 and GPIO OUT 1 and 2 to be defined as either
ACTIVE_LO or ACTIVE_HI.
GPIO IN: ACTIVE_LO is the default, which means the GPIO IN command will be activated on a high to
low edge of an external control pulse. Set to ACTIVE_HI to use a low to high edge.
GPIO OUT: ACTIVE_HI is the default, which means the GPIO OUT tally output will be high when in nor-
mal, burst or ramp record modes, and low when not. Set to ACTIVE_LO to reverse this.
PLAYBACK
Playback selects the Playback Video Format sub-menu.
This menu permits the video format and look used by the camera on playback to be specified.
MODE
Mode permits the video format used by the camera on playback to be specified.
720p: Video output is 1280 x 720 pixels. For 4K images the monitored image width corresponds to 4,096
pixels scaled down to 1280 pixels. This signal is available on the HD Preview (HD-SDI and HDMI), HD
Program (Dual Link HD-SDI), RED™ EVF, and RED™ LCD outputs.
1080p: Video output is 1920 x 1080 pixels. For 4K images the monitored image width corresponds to
3,840 pixels scaled down to 1920 pixels. This signal is available on the HD Preview (HD-SDI), HD Program
(Dual Link HD-SDI), RED™ EVF, and RED™ LCD outputs. RED™ EVF and RED™ LCD will display a 1280
x 720 pixel center cut of the larger 1920 x 1080 image.
Build 20 v20.1.6
76 76
©2009 RED.COM INC. OCTOBER 19, 2009