RED ONE Operation Manual page 59

A typical clip folder in this scenario looks as follows:
This specific clip includes eleven .R3D files, the first ten of which correspond to the pre-record and the
eleventh file corresponds to the normal record period. All have the same clip name.
NOTE: On playback on camera or in the RED Alert! ® or any QuickTime application, these eleven
individual .R3D files are seen as a single continuous video clip.
1. To enable PRE-RECORD, push in or down on joystick to place checkmark in PRE-RECORD check-
box.
2. DURATION box will highlight to allow you to choose between 10 SEC and 30SEC.
3. Twist joystick to change the highlighted DURATION box to the desired setting.
4. Move joystick right or up to select and exit.
To commence pre-record, push both the UNDO key and the RECORD key. The camera will commence
prerecord, indicated by the record tally light and timecode changing to yellow.
To enter record, push the RECORD key. This will be indicated by the record tally light and timecode
changing to red. To terminate pre-record, push the RECORD key a second time.
NOTE: When using Pre-Record, the Edge Code written to the digital magazine can become discon-
tinuous between clips, however Time Code is unaffected.
Build 20 v20.1.6
57
OCTOBER 19, 2009 ©2009 RED.COM INC.