Autodome Camera Or Receiver/Driver Site Configuration; Setting Fast Address Feature - Bosch LTC 5136/61 Instruction Manual

LTC 5136 Series | Instruction Manual | Setting Fast Addess Feature
4.5 AutoDome Camera or
Receiver/Driver Site Configuration
Follow the standard installation instructions provided
with the AutoDome Camera or Allegiant Series
Receiver/Driver unit to connect the data cable to the
unit. Set the address of the AutoDome camera or
receiver/driver, to the camera number that will be
selected on the Controller keypad. AutoDome cameras
also support address setting via the on-screen menu
Fast Address feature. The next section outlines setting of
the AutoDome's Fast Address.
Video signals from the camera site are NOT connected
to the Controller. The video signal(s) from the camera
site(s) should be connected to an appropriate viewing
monitor or other video processing equipment (switcher,
multiplexer, etc.).
5 SETTING FAST ADDRESS
FEATURE
Use the AutoDome's Fast Address feature to set the
AutoDome address via the controller and on-screen
menus instead of using the switch address
(thumbwheel). Fast Address can also be used to change
addresses, even if the thumbwheel switch is set.
The following is an example of how to Fast Address an
AutoDome (ID number 26636, logical camera #3).
The AutoDome being Fast Addressed has the switch
address (thumbwheel) set to 0.
1. Call up the camera to the screen you are
viewing (i.e. CAMERA-3-ENTER).
2. Press ON-999-ENTER. The screen shown in
FIGURE FA1 is displayed.
• Any camera without a Fast Address will
display the screen in FIGURE FA1 when
the ON-999-ENTER is used. Make sure you
are viewing the camera that you want to
program.
• If the camera's Fast Address is the same as the
keyboard address, ON-999-ENTER will
make the camera enter the Fast Address
mode. This is required to change or disable a
Fast Address.
Bosch Security Systems | 04 September 2003
• ON-998-ENTER causes all cameras,
regardless of Fast address status, to enter the
addressing mode.
Figure FA1
3. Press ON-26-ENTER. The screen shown in
FIGURE FA2 will be displayed. At this point,
any camera whose ID does not begin with 26
will exit the Fast Addressing mode.
Figure FA2
4. Press ON-636-ENTER. The screen shown in
FIGURE FA3 is displayed. At this point,
Camera ID 26636 will be the only camera in
the Fast Addressing mode.
Figure FA3
EN | 13