Appendices; Requirements In Accordance With Vds Class C; Selecting The Default Setting; Power Supply For Areas - Bosch MAP 5000 Series Installation Manual

MAP 5000
8

Appendices

This chapter contains information and instructions for creating programming that complies
with the requirements of a specific standard.
Notice!
Use the default setting for parameters that are not explicitly mentioned in this description. In
addition, the instructions for panel validation in the RPS for MAP programming software
must be followed.
8.1

Requirements in accordance with VdS class C

8.1.1

Selecting the default setting

4
See also
–
8.1.2

Power supply for areas

Refer to Connecting the LSN gateway, page 47.
8.1.3

Control centers

Refer to:
–
–
–
8.1.4

Connection to a management system

Refer to IP Interface, page 56.
8.1.5

Printer connection

Connecting the DR2020T printer is permitted only for service purposes.
8.1.6

Access levels

The standard distinguishes between four access levels (AE):
–
–
–
–
Selecting the access level
AE 1 Access for everyone, no authorization/code required
AE 2 Access for users, user passcode required
AE 3 Access for installers via control center
1.
2.
AE 3 Access for installers via RPS for MAP
Bosch Security Systems B.V.
Select VdS class C as the default property values setting.
Standard-compliant programming, page 58
Connecting the control center, page 44
Planning the system with IPP-MAP0005 power supply, page 7
Planning the system with ICP-MAP0012 CAN splitter module, page 11
AE 1 Access for everyone, no authorization/code required
AE 2 Access for users, user passcode required
AE 3 Access for installers via control center or via RPS for MAP
AE 4 Access for manufacturers via RPS for MAP
Open control panel enclosure.
Switch to installer mode (refer to Installer button, page 66).
Enter installer passcode.
Installation manual
Appendices | en 71
2019-09 | 25 | F.01U.168.332