1.2.3.1
Minimum Bend Radius for Link Cables
The link cables might be damaged if they are coiled too tightly. The minimum bend
radius for the link cable is 1.85 in. (47 mm).
Caution – Coiling the link cables with a smaller bend radius than listed above will
break the cables.
1.2.3.2
Cable Management Unit
The cable management unit contains two support brackets and a cable plate.
The support brackets attach with screws to the rear of the system rack. The cable
plate rests on the support brackets.
The cable plate has two positions (
In the normal position, the cable plate rests on the support brackets.
■
In the raised position, the cable plate rests slightly above the support brackets.
■
This position provides clearance for you to remove and replace an I/O boat.
FIGURE 1-11
1
3
Figure Legend
1
2
3
Cable Plate (Side Views of Normal and Service Positions)
Cable plate in the normal position (lowered)
Cable plate in the service position (raised)
Cable plate locking screw
).
FIGURE 1-11
2
Chapter 1
Overview
1-15