Replacing An I/O Boat; Replacing A Boat In A Single Boat Configuration - Sun Microsystems SPARC Enterprise T5120 Installation And Service Manual

12. Move the cable plate back into the normal position (
cable plate locking screw(s).
13. Attach the I/O cables to the PCI cards.
14. Attach the I/O cables to the cable management unit on the External I/O
Expansion Unit.
Allow approximately 2 inches (50 mm) of cable movement. This permits
movement of the cable plate from its normal location to its service position.
15. Install the remaining link card in the host server:
a. If your host server has low-profile slots, replace the full-height card bracket
For
instructions.
b. Turn off the host server.
c. Install the link card in the host server.
d. Connect the link cable between the link cards in the server and the second
16. Turn on the host server.
17. Start the domains that are connected to the External I/O Expansion Unit.
For information about turning on a domain, refer to the documentation for the
server.
4.9

Replacing an I/O Boat

4.9.1

Replacing a Boat in a Single Boat Configuration

The External I/O Expansion Unit must be powered off during this procedure.
1. Use an antistatic strap for this procedure.
2. Stop the domains that are connected to the External I/O Expansion Unit.
For information about stopping a domain, refer to the documentation for the
server.
4-16 External I/O Expansion Unit Installation and Service Manual for SPARC Enterprise T5xxx Servers • April 2011
on the link card with a low-profile card bracket (
Step b, Step c, and Step
I/O boat.
16, refer to documentation for your host server for
) and tighten the
FIGURE 4-4
).
FIGURE 2-13