Ext Sensor Messages - Sun Microsystems SPARC Enterprise T5120 Installation And Service Manual

Ext info Messages (listed in alphabetical order) (Continued)
TABLE D-4
Message
Ext info /SYS/IOX@nnnn/PSn THERMCTRL/T_AMBIENT has exceeded
high warning threshold
Ext info /SYS/IOX@nnnn/PSn THERMCTRL/T_AMBIENT is within
normal range
Ext info /SYS/IOX@nnnn/PSn THERMCTRL/T_HOTSPOT has exceeded
high warning threshold
Ext info /SYS/IOX@nnnn/PSn THERMCTRL/T_HOTSPOT is within
normal range
Ext info /SYS/IOX@nnnn/PSn offline, ready to remove
Ext info /SYS/IOX@nnnn/PSn online
Ext info /SYS/IOX@nnnn/PSn over-current warning
Ext info /SYS/MB/PCIEn/LINK CONTROLLER/MGMT_BUS management
link restored
D.6

Ext sensor Messages

Service is required, but a specific FRU cannot be identified as the cause. Use
TABLE D-5
Ext sensor Faults (listed in alphabetical order) (1 of 4)
TABLE D-5
Message
Ext sensor /SYS/IOX@nnnn DEMUX/PORT=n I2C bus taken by
second system. Fault not isolated.
Ext sensor /SYS/IOX@nnnn DEMUX/PORT=0 I2C no device
response. Fault not isolated.
Ext sensor /SYS/IOX@nnnn DEMUX/PORT=1 I2C no device
response. Fault not isolated.
Ext sensor /SYS/IOX@nnnn FANCTRL I2C interrupt failure.
Fault not isolated.
Ext sensor /SYS/IOX@nnnn FANCTRL I2C no device response.
Fault not isolated.
Ext sensor /SYS/IOX@nnnn FANCTRL reset. Fault not
isolated.
to find help in diagnosing the fault.
Appendix D
Meaning
PSU n, thermal information
PSU n, thermal information
PSU n, thermal information
PSU n, thermal information
PSU n, external power information
PSU n, external power information
PSU n, information
Bus recovery information for the
boat attached to PCI Express slot n
See
Section D.6.9, "I2C Bus Taken by Second
System" on page D-16
Section D.6.2, "Main I2C Bus" on
page D-11
Section D.6.2, "Main I2C Bus" on
page D-11
Section D.6.6, "Interrupt Signal
Failures" on page D-14
Section D.6.2, "Main I2C Bus" on
page D-11
Section D.6.14, "Fan Controller Reset"
on page D-19
Troubleshooting with ILOM Diagnostic Messages D-7