Replacing The Power Supply; Figure 8-1 Removing The Power Supply - Sun Microsystems Ultra 2 series Service Manual

Power supply
J5/J6
J4
J3
J1
J2
Captive screw (2)
Chassis rear
Removing the Power Supply
FIGURE 8-1
8.1.2

Replacing the Power Supply

Caution –
Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
Caution –
The AC power cord must be disconnected while the power supply is
being removed and replaced. Do not reconnect the power cord while the power
supply is outside of the chassis.
1. Position the power supply into the chassis.
Chapter 8 Major Subassemblies 8-3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com