Figure 3-8 Replacing The Ultra 60 Power Supply - Sun Microsystems Ultra 80 Upgrade Manual

8. Replace the power supply as follows (
a. Feed the power supply cables through the chassis opening; support the power
supply cables while engaging the power supply into the chassis rails.
b. Position the power supply into the chassis.
c. Slide the power supply toward the chassis front.
d. Connect the power cables to the motherboard.
e. Connect the peripheral cable connector to the power supply.
f. Replace the peripheral power cable through the cable routing clips.
Power cable
Replacing the Ultra 60 Power Supply
FIGURE 3-8
g. Slide the power supply toward the chassis front until the power supply rear
panel is flush with the chassis.
h. Using a No. 2 Phillips screwdriver, tighten the captive screws securing the
power supply to the chassis.
Note – Tighten the captive screws in a clockwise order beginning with the upper
right captive screw.
FIGURE 3-8
Chapter 3 Upgrading from an Ultra 30 or an Ultra 60 System
):
3-11