Replacing The Foot; Speaker Assembly; Removing The Speaker Assembly - Sun Microsystems Ultra 60 Service Manual

8.6.2

Replacing the Foot

1. Position the foot (
2. Using a number 2 Phillips-head screwdriver, tighten the screw securing the foot to
the chassis.
3. Position the system unit in the operating position.
4. Power on the system unit.
See Section 6.1, "Powering On the System Unit" on page 6-2.
8.7

Speaker Assembly

To remove and replace the speaker assembly, proceed as follows.
8.7.1

Removing the Speaker Assembly

1. Power off the system unit.
See Section 6.2, "Powering Off the System Unit" on page 6-3.
2. Remove the side access cover.
See Section 7.1, "Removing the Side Access Cover" on page 7-2.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach the wrist strap.
See Section 7.2, "Attaching the Wrist Strap" on page 7-3.
4. Remove the PCI fan assembly.
See Section 8.2.1, "Removing the PCI Fan Assembly" on page 8-5.
5. Disconnect the speaker cable from the motherboard (
6. Using a number 2 Phillips-head screwdriver, remove the screw securing the
speaker assembly to the chassis.
7. Remove the speaker assembly.
).
FIGURE 8-7
).
FIGURE 8-8
Chapter 8 Major Subassemblies 8-17