Shroud Assembly Speaker; Removing The Shroud Assembly Speaker - Sun Microsystems Ultra 2 series Service Manual

3. Connect the speaker connections.
4. Connect the fan connections.
5. Detach the wrist strap.
6. Replace the system unit cover.
See Section 7.3 "Replacing the System Unit Cover" on page 7-4.
7. Connect all cables to the back of the system or server unit.
8. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
8.4

Shroud Assembly Speaker

To remove and replace the shroud assembly speaker, proceed as follows.
8.4.1

Removing the Shroud Assembly Speaker

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the System Unit Cover" on page 7-1.
Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
4. Using a number 2 Phillips screwdriver, remove the screw securing the speaker to
the shroud assembly (
5. Disconnect the speaker connections.
6. Remove the speaker.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Use proper ESD grounding techniques when handling components. Wear
).
FIGURE 8-6