Memopad Numbers - Icom i9100 Instruction Manual

SPEECH Level
25.
Adjust the speech audio output level to between 0%
(no output) and 100% (maximum output).
SPEECH Language
26.
Select English or Japanese as the speech language.
SPEECH Speed
27.
Select HIGH (faster) or LOW (slower) speech speed.
SPEECH S-Level
28.
The signal level announcement with the voice synthe-
sizer can be turned ON or OFF.
• OFF : Signal level is not announced. Operating fre-
quency and mode are announced.
• ON : Signal level, operating frequency and mode
are announced.
29. SPEECH [MODE] SW
Turn the Operating Mode Speech function ON or OFF.
When this function is ON, the selected operating mode
is verbally announced when a mode switch is pushed.
• OFF : The operating mode Speech function is OFF.
• ON : The operating mode Speech function is ON.
30. [SPEECH/LOCK] SW
Select the [SPEECH/LOCK] switch action.
• SPEECH/LOCK : Pushing the [SPEECH/LOCK]
switch turns ON the voice synthe-
sizer function.
Holding down the [SPEECH/LOCK]
switch turns the dial lock function
ON or OFF.
• LOCK/SPEECH : Pushing the [SPEECH/LOCK]
switch turns the dial lock function
ON or OFF.
Holding down the [SPEECH/LOCK]
switch turns ON the voice synthe-
sizer function.

Memopad Numbers

31.
Set the number of available memo pads to 5 or 10.
See page 144 for details.
(Default: 50%)
(Default: English)
(Default: HIGH)
(Default: ON)
(Default: OFF)
(Default: SPEECH/LOCK)
(Default: 5)
32. MAIN DIAL Auto TS
Set the Auto Tuning Step function for [MAIN DIAL].
When rapidly rotating [MAIN DIAL], the tuning step au-
tomatically changes as selected.
There are two types of auto tuning steps: LOW (Faster)
and HIGH (Fastest).
• OFF : Auto tuning step is turned OFF.
• LOW : Approximately 2 times faster.
• HIGH : Approximately 5 times faster when the tuning
step is set to 1 kHz or smaller steps; approxi-
mately 2 times faster when the tuning step is
set to 5 kHz or larger steps.
MIC Up/Down Speed
33.
Set the rate at which frequencies are scanned while
holding down the microphone [UP]/[DN] switches.
• LOW : Low speed (25 tuning steps/second)
• HIGH : High speed (50 tuning steps/second)
Quick RIT Clear
34.
Select the RIT/∂TX frequency offset clearing opera-
tion with [CLEAR].
• OFF : Holding down [CLEAR] for 1 second clears the
RIT and ∂TX frequency offset.
• ON : Pushing [CLEAR] instantly clears the RIT and
∂TX frequency offset.
AFC Limit
35.
Turn the AFC (Automatic Frequency Control) limit
function ON or OFF.
The AFC function automatically compensates the tun-
ing when a received frequency drifts or goes off fre-
quency.
• OFF : The AFC function continues to tune until the
displayed frequency changes to reflect the
center of the signal.
• ON : The AFC function stops tuning when the fre-
quency goes off the limited frequency range,
even if received frequency is off frequency.
AFC limit value:
IF Filter width AFC limit value
15 kHz
10 kHz
7 kHz
14
SET MODE
(Default: HIGH)
(Default: HIGH)
(Default: OFF)
(Default: ON)
±10 kHz
±7 kHz
±5 kHz
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
164