Icom i9100 Instruction Manual page 204

18
CONTROL COMMAND
D Data content description (continued)
• Memory content setting
Command : 1A 00
q w e r
@8 #5
q Frequency band setting
00 : HF/50 MHz frequency band
01 : 144 MHz frequency band
02 : 430 MHz frequency band
03 : 1200 MHz frequency band
w, e Memory channel number
0001–0099 : Memory channel 1 to 99
0100 : Programmed scan edge 1A
0101 : Programmed scan edge 1b
0102 : Programmed scan edge 2A
0103 : Programmed scan edge 2b
0104 : Programmed scan edge 3A
0105 : Programmed scan edge 3b
0106 : Call channel
r Split and Select memory settings
r
X X
0: Select memory OFF
1: Select memory ON
0: Split OFF
1: Split ON
When the program channel is selected, both settings
should be "0."
When the Call channel is selected, the Select mem-
ory setting should be "0."
t–o Operating frequency setting
See '• Operating frequency.' (p. 190)
!0 , !1 Operating mode setting
See '• Operating mode.' (p. 190)
!2 Data mode setting
1 byte data (XX)
00: Data mode OFF
01: Data mode ON
!3 Duplex and Tone settings
!3
X
195
t o !0 !1 !2
#6 $3 $4 %1
X
0: OFF, 1: Tone
2: TSQL, 3: DTCS
0: Duplex OFF
1: Duplex−, 2: Duplex+
!3 !4 !5 !7
t %1 %2 ^0
!4 Digital squelch setting
!4
X 0
0: Digital squelch function OFF
1: Digital call sign squelch function ON (DSQL)
2: Digital code squelch function ON (CSQL)
!5 – !7 Repeater tone frequency setting
!8 – @0 Tone squelch frequency setting
See '• Repeater tone/tone squelch frequency setting.'
(p. 193)
@1 – @3 DTCS code setting
See '• DTCS code and polarity setting.' (p. 193)
@4 Digital code squelch setting
See '• Digital code squelch setting.' (p. 193)
@5 – @7 Duplex offset frequency setting
See '• Duplex Offset frequency setting.' (p. 192)
@8 – #5 Destination call sign setting
(8 characters; fixed)
#6 – $3 R1 (Access/Area repeater) call sign setting
(8 characters; fixed)
$4 – %1 R2 (Link/Gateway repeater) call sign setting
(8 characters; fixed)
See '• DV TX call signs setting.' (p. 194)
%2 – ^0 Memory name setting
9 characters (Fixed)
See '• Character code setting.' (p. 190)
About clearing operation:
"1A 00" command with the format as below clears the
data of the selected memory channel.
w, e
r
t or later : None
NOTE:
• The same data as t–%1 are stored in t–%1 .
• When the Split function is ON, the data of t–%1
is used for transmit.
• Even if the Split function is OFF, enter the data
into t–%1 to match your transceiver. We recom-
mend that you set the same data as t–%1 .
!8 @0 @1 @3 @4
: Memory channel 0 to 99
: FF
@5 @7