Calling A Specific Station - Icom i9100 Instruction Manual

8
DV MODE OPERATION

■ Calling a specific station

This section describes how to call a specific station
using the DR mode.
When the Link repeater (R2) is set to "GW," the des-
ignated gateway repeater is automatically set as the
Link repeater, and you can make a call to a specific
station through the internet.
q Set your own call sign.
w Hold down [DV•DR] for 1 second to select the DR
mode.
• The last used access repeater is displayed.
- If the displayed frequency band on the SUB Band is
the same as that of the last used access repeater, se-
lecting the DR mode on the MAIN Band will automati-
cally move the frequency band on the SUB Band to
the Main Band display, and turn OFF the SUB Band
display.
e Rotate [MAIN DIAL] to select the desired access
repeater.
• Only the repeaters, whose "R1USE" setting is set to
YES, or Access repeater scan targets are displayed.
(pp. 90, 100)
r Push [UR](F-4) to enter the UR call sign selection
mode.
t Rotate [MAIN DIAL] to select a individual station
call sign.
• First selecting the station call sign memory groups
(U01–U99) by pushing [TS•GRP] makes it more conve-
nient.
y Hold down [UR](F-4) for 1 second to enter the Link/
Gateway repeater (R2) selection mode.
Making a call to an individual station through your
local area (access) repeater (Local Area call)
q
MY call sign
JA3YUA
u Rotate [MAIN DIAL] to select "NOT USE✱."
i Push [UR](F-4) to exit the Link repeater (R2) selec-
tion mode.
o Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
• The MAIN Band TX/RX indicator lights red.
!0 Release [PTT] to receive. (or push [TRANSMIT]
again)
If you want to save this temporary setting, push [MW]
to enter the memory select write mode. (p. 102)
103
Zone
w e
Area
Repeater q NARA43
Station call sign
JG3YMK
[TRANSMIT]
r
(JP3YHL)
MAIN Band TX/RX indicator
D1
CS
[UR] [TS•GRP]
[DV•DR]
[UR] [MW]
R : N O T U S E �
2
C D R > C S U R
NOT USE✱
[MAIN DIAL]
[MAIN DIAL]
DSET