Other Setting - SATO HT200e Operator's Manual

SECTION 2: INSTALLATION AND SETUP

OTHER SETTING

THE SCREEN FOR DISCOUNT RATE SETTING
［ Ｗ Ａ Ｓ
1 ￡ ・ ・ ・ ・ ・ ・
Ｄ Ｉ Ｓ Ｃ Ｏ Ｕ Ｎ Ｔ Ｒ Ａ Ｔ Ｅ
2 ［ ・ ・ ］ ％
Note 1) Discount rate is a prerequisite, so that 0% can not be allowed.
Note 2) Where asterisk mark or "*" can be seen in the upper right on the screen, entry by scanner can be made
possible.
Note 3) Fractions should be omitted.
SCREEN FOR EURO CURRENCY CONVERSION RATE SETTING
［ Ｐ Ｒ Ｉ Ｃ Ｅ
1 ￡ ・ ・ ・ ・ ・ ・
Ｃ Ｏ Ｎ Ｖ Ｅ Ｒ Ｓ Ｉ Ｏ Ｎ Ｒ Ａ Ｔ Ｅ
2 Ｃ １ ＝ ［ ０ ０ ０ ０ ． ０ ０ ０ ０ ０ ０ ］
For the entry of conversion rate, enter within 6 digits (Max.) without decimal points. In addition, C should be
or more for this entry.
１
For setting conversion, the rate determined should be entered
e.g.) 1.95583 (Germany)
1234 5 67890
．
Note 1: After four places of decimal will not be printed for the result of calculation.
(Three places of decimal will be rounded off.)
Note 2: For the calculation of the currency mark becoming C , where the result of calculation is rounded off, and
the value before calculation can not be calculated back precisely with the method of the C becoming the
currency mark.
IMPORTANT 1) Discount rate is a prerequisite, so that 0% can not be allowed.
IMPORTANT 2) Where asterisk mark or "*" can be seen in the upper right on the screen, entry by scanner can
be made possible.
Complimentary note: Dual pricing means that the currency for each country and Euro will be printed in double
price.
Page 2-36
２ ５ ％ ］
］
( This entry is not VALID.)
On the WAS entry screen for the markdown format
*
(16, 17, 18, 19, 25), press [FNC2], so that the
discount rate being set will appear on the upper
screen.
Key new discount rate, and press [ENTR] so that it
returns to the process No. 1. Where [AC] is pressed,
the data entered will be cleared.
* On the PRICE entry screen for the dual pricing format
(20, 21, 28, 29), press [FNC2].
Conversion rate (a prerequisite) MUST be entered:
Where [ENTR] is pressed, it can be back to the
process No. 1. When [AC] is pressed, the date
entered will be cleared. Note: Where no rate is set,
the process No. 2 will automatically be displayed
before the No. 1.
０ ．
SATO HT200e