SATO HT200e Operator's Manual page 69

SECTION 4 FREE MODE
：
FIELD SETTING FOR SEQUENTIAL NUMBER
Based on the field designation, the setting, in which "12: Normal/Sequential Number" is specified,
is described.
Digit Designated item
position
(s)
1, 2 Field designation
3 Font selection
4, 5, 6 Vertical position
7, 8, 9 Horizontal position
10 Rotation position
(Note 1)
11 Character pitch
(Note 2)
12, 13 Character count
14 Vertical expansion
15 Horizontal expansion
I nput Check Digits
16 Input check
17 Function for sequential
number
18 Reserved
19 0 insertion in
numbering sequence
20 Preset
21 Reserved
Note 1: For the position of rotation, see 1. in Additional Information for Parameter.
Note 2: When horizontal direction is enlarged, space between characters will increase.
Note 3: Copy from the field of sequential number to the field is not allowed.
Page 4-6
12: Normal/Sequential Number
0: X1 (20 x 50 dots)
1: X2 ( 8 x 20 dots)
2: X3 (13 x 21 dots)
4: OCR-B(20 x 24 dots)
001 to 784 dot (s): Vertical print position
000: Entry only, where print is not required.
001 to 384 dot (s): Horizontal print position
0: 0° 2: 180°
1: 90° 3: 270°
0 to 9 dot (s)
01 to 08: Number of characters in the field
1 to 4: Magnification of vertical direction to character
1 to 4: Magnification of horizontal direction to character
5: Numeric only 6: Numeric in all digits
8: Numeric and uppercase in English only
9: Numeric and uppercase in English in all digits
0: Invalid
1 to 9: Valid for the table of sequential number
0: Determined
0: Without 0 insertion
1: With 0 insertion
0: No entry in printing preset (Not displayed)
1: Entry in printing preset (Displayed)
0: Determined
Description
SATO HT200e