SATO HT200e Operator's Manual page 9

SAFETY PRECAUTIONS
How to Handle Head Detergent:
The agent is flammable. Heating it up or throwing it into the fire is
ABSOLUTELY FORBIDDEN.
DO STORE at the best place, out of reach of children to avoid accidents.
If consumed, immediately go to the nearest Clinics for treatment
Connection for Optional Cable/Scanner:
Power of the printer should be turned OFF when the optional cable or scanner is
to be connected to the printer. Note that if the printer is left in an ON condition
when connecting optional peripherals, it may damage the device or the
communication port due to short circuit.
Battery Pack/Power Unit:
Power Unit/Battery charger:
SATO HT200e
- DO NOT Dispose off
REMODEL the battery pack.
- DO NOT HEAT or THROW the device into the presence of a fire. Any
action causing short-circuit is NOT ALLOWED, either.
USE specified charger for recharging the battery pack.
-
- DO NOT WET or SOAK the equipment in water or sea-water. If wet or
soaked, it may cause heat to the cell or a rust to the terminal.
- USE AC100V - 220V which is solely specified for this unit. If not, it may
cause a fire or electric shock.
- USE specified charger when charging battery pack. If not, it may cause
explosion in the cell, liquid leakage, a fire, or electric shock.
- DO NOT DAMAGE or compress DC cord. Note that a result of overload
to the printer, overheat, cord-pulling, or any other process may cause a
fire or electric shock.
- DO NOT PROCESS, intentionally BEND, TWIST, or PULL DC cord. If
use the part in that state, it may cause a fire, electric shock, or unsus-
pected trouble.
Danger
a battery pack or power unit. DO NOT
V