SATO HT200e Operator's Manual page 20

SECTION 2: INSTALLATION AND SETUP
WHAT YOU GET
Consider the following when unpacking the printer.
• The shipping container should stay right side up.
• Lift the printer straight up and out of the box.
• Remove the two shipping restraints.
• Remove the plastic covering from the printer.
• Remove the accessory items from their protective container.
• If the printer has been stored in a cold environment, allow it to reach room temperature
before powering it on.
• Set the printer on a solid flat surface. Inspect the shipping container and printer for any
signs of damage that may have occurred during shipment.
The HT200e Thermal printer comes packed in a protective carton. Included in the carton case
the following items:
• HT200e Printer
• Quick Guide
• CD ROM
• Head Cleaning Sheet
• Power Cable and Reel holder
After taking the HT200e from the carton and removing the plastic cover, it is ready for installation.
Consider the following when setting up the printer.
• Locate a solid flat surface with adequate room to set the printer. Make sure there is
enough room above the printer to provide clearance for loading labels, reading the LCD
screen and accessing the keypad.
• If the printer is to be used in conjunction with a host computer or terminal, the maximum
distance for RS232C cables is10 m. Cables can be purchased locally and their configura-
tion will depend upon the host system.
• For information on interfacing the printer to a host system.
• If the printer is to be used with an AC Adaptor, make sure that the proper power source is
available.
Page 2-2 SATO HT200e