SATO HT200e Operator's Manual page 116

5.
Table data: It can be sent with DATA STORE/RECALL in data maintenance mode.
Setting for table data:
For table No., set "0" in the beginning of character and then data in 4 bytes. Data in the same
format as fixed data of the printer parameter shall be set for table data. In sequence of table
data 1, 2, and 3, transmit them.
For one data to be transmitted, SOH + H, I, and J as header (as follows) and EOT as trailer
should be put for all data sets (items).
SOH H
EOT
SOH I
EOT
SOH J
EOT
Note: Parenthesis shows the number of byte for each item.
SATO HT200e
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
STX Table No. (4)
Table data (32)
Table data (32)
Table data (32)
Table 1: Max. 200 data
Table data (32)
Table data (32)
Table data (32)
Table 2: Max. 200 data
Table data (32)
Table data (32)
Table data (32)
Table 3: Max. 200 data
SECTION 6: ON LINE
ETX
ETX
ETX
ETX
ETX
ETX
ETX
ETX
ETX
Page 6-11