SATO HT200e Operator's Manual page 148

SECTION 8: CLEANING AND MAINTENANCE
THE MEMORY BACKUP BATTERY
The RAM memory in the HT200e is maintained with a lithium battery located on the main PCB. If
you receive a "PRINT BATT LOW" or "CHNG PRINT BATT" error message on the LCD display,
this battery must be replaced. Back up the data stored in the printer before replacing the battery.
1. SUPPLIES NEEDED
• No. 2 Phillips screwdriver
• CR2450 Lithium Cell Battery
2. HOW TO DO
1. Turn the printer off and remove the power cable.
2. Place the printer on its side to give access to the PCB.
3. Remove the PCB cover (1).
4. Remove the battery (2) as shown below.
5. Replace the battery.
6. Replace the PCB cover.
Page 8-6 SATO HT200e