SATO HT200e Operator's Manual page 96

SECTION 5 PRESET, TABLE DATA
：
PRINTING OF PRESET DATA
Ｆ Ｏ Ｒ Ｍ Ａ Ｔ Ｎ ｏ
1 ［ ・ ・ ］
［ Ｐ Ｒ Ｅ Ｓ Ｅ Ｔ ］
2 Ｐ Ｒ Ｉ Ｎ Ｔ
Ｄ Ｅ Ｌ Ｄ Ｕ Ｍ Ｐ Ｍ Ａ Ｓ Ｔ Ｅ Ｒ
Ｐ Ｒ Ｅ Ｓ Ｅ Ｔ Ｎ Ｏ ． Ｉ Ｎ Ｐ Ｕ Ｔ ＊
3 ・ ・ ・ ・
［ Ｉ Ｔ Ｅ Ｍ
4 ・ ・ ・ ・ ・ ・ ・ ・ ・
［ Ｐ Ｒ Ｉ Ｃ Ｅ
5 ￡ ・ ・ ・ ・ ・ ・
［ Ｑ Ｔ Ｙ
6 ・ ・ ・ ・
Ｐ Ｒ Ｉ Ｎ Ｔ Ｉ Ｎ Ｇ
7
Note: Where asterisk mark or "*" can be seen in the upper right on the screen, entry by scanner
can be made possible.
Page 5-4
Ｈ Ｔ ２ ０ ０ ｅ
[RCL]
Ｓ Ｔ Ｒ Ｍ Ｏ Ｄ Ｉ Ｆ Ｙ
[ENTR]
＜ Ｐ Ｒ Ｉ Ｎ Ｔ ＞
[ENTR]
］
[ENTR]
］
[ENTR]
］
[ENTR]
Press [RCL], so that it goes from the modes of the
print to the preset.
The screen for the selection of preset printing will
be displayed: Press [ENTR], so that it goes to the
entry of preset number.
The preset No. that is required to print can be
entered: Press [ENTR], so that it displays the pre-
set data specified.
Since the contents of data differ, based on the
format number retrieved, press [ENTR] by
checking data in each field.
Enter the No. of paper within 4 digits, and press
[ENTR]. Note that neither 0 nor un-entry is
permitted.
Preset will start printing:
Note: where the No. of print becomes 0, it goes
back to the process No. 3.
SATO HT200e