SATO HT200e Operator's Manual page 109

SECTION 6: ON LINE
2.
Data regulating print position
This command specifies value that regulates print position.
･
<M> [ 1B (H), 4D (H) ] nnn
Designation
for vertical
E
size of paper
S M
C
1 2 3
Digit
position
1 to 3 Designation for vertical size of
paper
Designation for horizontal size of
4 to 5
paper
6 Type of paper
Regulation of vertical position
7
(Direction)
8 to 9 Regulation of vertical position
(Volume of migration)
Regulation of horizontal position
10
(Direction)
11 to 12 Regulation of horizontal position
(Volume of migration)
13 to 22 Name of format
23 to 32 Name of label
Page 6-4
････
n (32 bytes can be designated.)
Designa- Type
tion for Regulation of
of
horizontal
paper
size of
paper
4 5 6 7
Item
It is displayed in "mm".
It is displayed in "mm".
It can select from the following:
It designates direction that can be fine adjusted for print.
Value; 1:+, 0: -
It designates unit for dot in numbers. 1 dot = 0.025mm
It designates direction that can be fine adjusted for print.
Value; 1: +, 0: -
It designates unit for dot in numbers. 1 dot = 0.025mm
It specifies name of each format.
It specifies name of label for each format.
Regulation of
vertical horizontal
position position
8 9 10 11
Description
1: NORMAL (Non-gap label for HT200e)
2: OPTION (M32 label)
[Direction that print position can be controlled]
Hori.
-
Up to 5mm or 40 dots in all directions can be
controlled. Note: Some position of print may
vary the number of dot that is adjustable.
Name of Name of
format
12 13 to 22 23
Ver. -
+
+
SATO HT200e
label
to 32